Home Products Standard Range Materials Industries Capabilities Quality About FAQ Guides Send RFQ
Home › Guides › Silicone vs EPDM Outdoors
Guide

Silicone vs EPDM for outdoor seals

Both resist weather and ozone. EPDM covers most outdoor seals from about −45°C to +150°C. Silicone takes over when the temperature goes higher or lower than that.

Side by side

Silicone and EPDM compared

Property (typical compounds)Silicone (VMQ)EPDM
Temperature range−60 to +225°C−45 to +150°C
Hardness range20 to 90 Shore A30 to 90 Shore A
Ozone and weatherExcellentExcellent
Water and steamGoodExcellent
Acids and basesFairExcellent
Mineral oilFairNot suitable
FuelPoorNot suitable
How to choose

Which one fits your seal.

Choose EPDM when

The seal lives outdoors below about +150°C: panels, enclosures, solar junction boxes, doors and windows, HVAC with water and steam, or equipment washed with cleaning chemicals.

Choose silicone when

The seal runs hotter than EPDM can take, such as near LEDs and heaters, or very cold; or you need flame-retardant grades.

Oil and fuel

When the seal also sees oil or fuel

EPDM is not suitable for mineral oil or fuel, and silicone is only fair with oil and poor with fuel. Use NBR for oil, or FKM (Viton-type) for oil or fuel at heat.

Ratings are for typical commercial compounds. Figures are indicative and are confirmed for your application before tooling.

Sources: o-ring.info, Basic properties of elastomers; Mykin Inc, Rubber properties; Delta Rubber, Rubber material comparison guide; GMORS, VMQ silicone (silicone temperature range).

FAQ

Common questions

Is EPDM UV resistant?
Yes. EPDM resists ozone, UV and weathering. Typical compounds rate excellent for ozone and weather, the same as silicone.
Which is better for a solar panel or junction box seal?
EPDM for most outdoor solar seals within its temperature range. Silicone where the part runs hotter than EPDM can handle.
Which is better for LED street light gaskets?
Silicone where the gasket sits close to hot LEDs or drivers. EPDM where it stays within its temperature range.
Request for quote

Send your RFQ

Tell us what you need. Fields marked * are required. Everything else helps us recommend the compound.

About Exonel Industries

Exonel Industries makes custom moulded and extruded rubber components in Howrah, Kolkata, West Bengal, and supplies manufacturers across India. We work in six base polymers, Silicone, EPDM, FKM, NBR, Neoprene and SBR, formulated into hundreds of compounds. Compounding, tooling and production are done in-house. Send a drawing, a sample or a specification for a quote.

💬 ✉
WhatsApp Call Email Send RFQ