Made to your drawing or sample.
Send a drawing, a sample or just the problem. We select the polymer, compound the rubber, cut the tooling and make the part — moulded or extruded — in-house in Howrah.
Start a custom part →
One workshop, the whole chain.
Formulation, tooling and production happen under one roof — so we take a part from drawing or sample to repeatable production, holding the compound and dimensions along the way.
Bespoke to drawing
Give us a drawing or spec and we engineer and make the part.
Prototyping & tooling
From a sample or idea to a prototype, then to production tooling.
Ready-to-use compounds
Mixed rubber compounds formulated to your requirement.
Replace an imported part.
Buying a moulded or extruded rubber part from overseas? Send the sample — we reverse-engineer the geometry, match the compound and localise it, shortening lead times and simplifying supply.
Send a sample
We measure and match geometry and material.
We localise it
Compounded, tooled and produced here in Howrah.
Common questions.
Can you match an imported rubber part?
Yes — send the sample and we reverse-engineer the geometry, match the compound and produce a localised equivalent.
Do you make parts from just a sample?
We can. A sample, a drawing or a clear spec is enough to start — the more detail on material and duty, the closer the match.
Do you take prototypes and low volumes?
Yes — prototypes and low volumes are welcome, and the same tooling scales up to production later.
